Specialized part 2

TonyW1967 24.11.2023 17:16

OK, considering the quick reactions to my other question, on my Specialized Epic FSR Comp carbon frame, there are a number of holes which are not plugged – in the attached photos you can see them, and the second photo shows a hole that IS plugged (lower part of the frame) – Are these holes supposed to be plugged?

0 2
Zpět Reagovat
- novas752 24.11.2023 17:44
  
  All that holes on the side of tube are for clamps of front ferailleur cable = they are no longer needed and can be pluged.
  
  0 0
  Zpět Reagovat
  - TonyW1967 26.11.2023 09:50
    
    Thanks, would you know where I can buy the plugs?
    
    0 0
    Zpět Reagovat
- rejdy 24.11.2023 18:19
  
  You do not need to create new thread for each new question, you can pose question in existing one
  
  The center hole in the picture 1 is where normally the front derailleur housing comes out. Two holes on the side and the one in the picture 2 are there in case you want to route rear brake externally to attach cable guides. But normally, rear brake is routed internally, so these holes serve no purpose.
  
  0 0
  Zpět Reagovat
  - rejdy 24.11.2023 18:47
    
    One correction:
    
    front derailleur housing usually comes out just next to rear derailleur housing, so the center hole in picture 1 is not for cable, but there should be a bolt (in your case it looks like it is missing) that you tighten and it prevents the cables from moving in or out of the down tube.
    
    1 0
    Zpět Reagovat
- TonyW1967 25.11.2023 17:24
  
  Thanks for the guidance – should I buy blanks for those holes, or leave them open?
  
  0 0
  Zpět Reagovat
  - rejdy 26.11.2023 11:19
    
    Side holes used to be open like this from the production, of course you can cover them if you find sth. that fits.
    
    0 0
    Zpět Reagovat

Nová reakce na zakládající

Podobné diskuse